Public Shaming
My Mrs. was nice enough to take Non Tactical Car to the car wash. I asked to make sure she removed my arfcom BFL magnet before going through. She did. But put it on wrong and now it’s stuck. Any ideas?
Remember, I do this to entertain me, not you.
Uncle Pays the Bills
 |
|
Find Local
|
Categories
- ATF (769)
- Death Match (10)
- Eminent Domain (225)
- In the bag (9)
- Notes to Junior (546)
- Poker (74)
- Recipes (142)
- Shotgun Noob (11)
- The Airing of Grievances (19)
- uncategorized (47,725)
May 30th, 2015 at 1:26 pm
Try gently sawing under an edge with dental floss.
May 30th, 2015 at 1:40 pm
that could work. Something fine you can get under the edge and then pull it up. Dental floss is pretty tough.
May 30th, 2015 at 2:48 pm
Is the cam pin jammed?
May 30th, 2015 at 2:54 pm
Just executing a tactical reposition, firing from a ninja inspired hold. Anyway, maybe a little light heat to loosen it up?
May 30th, 2015 at 4:02 pm
A good sharp hatchet will take it right off. : )
May 30th, 2015 at 4:10 pm
Use a credit card to lift a corner. Heat might help too.
May 30th, 2015 at 4:54 pm
Hoppe’s #9?
May 30th, 2015 at 5:16 pm
Bigger tires on the right side.
May 30th, 2015 at 7:02 pm
Plastic putty knife.
May 30th, 2015 at 7:08 pm
Sawzall
May 30th, 2015 at 7:22 pm
Bread. Apples. Very small rocks. Cider! Great gravy. Cherries. Mud. Churches. Lead. A duck!
May 30th, 2015 at 9:38 pm
Have you tried slamming it into the ground while pulling on the handle?
May 30th, 2015 at 10:43 pm
Get a corner up and spray soapy water down behind it.
May 30th, 2015 at 11:32 pm
Trade the non-tac for an H1, then you won’t need no steenkin’ sticker to be all tactikewl…
May 31st, 2015 at 9:56 am
Tell everyone it’s Stag’s new left-handed upside-down upper, inspired by the shooting style of Liberian revolutionaries.
May 31st, 2015 at 11:45 am
The laws of physics may be your friend here. Get a strong bar magnet and either A) use it to attract an edge of the decal away from the car or B) put it on the other side of the sheet metal [if you can] to repel the decal away from the car (like poles oppose).
May 31st, 2015 at 4:59 pm
Time to buy a new car…
May 31st, 2015 at 6:06 pm
Replace it with a proper Mosin-Nagant bolt face.
May 31st, 2015 at 6:50 pm
Garage compressor air nozzle. 100psi should lift an edge.
May 31st, 2015 at 7:38 pm
Just go to the nearest self serve carwash, dump in the quarters and put the high pressure nozzle on soapy water and have at it. The hot spray should take it off, once you get any flap raised the rest will just work it’s way in.
May 31st, 2015 at 7:42 pm
Just a thought: Do you have a pressure washer with a wide nozzle? Back off about a foot, trigger it and move in towards an edge till you see it lift.
May 31st, 2015 at 7:59 pm
You did say it was a magnet didn’t you?
May 31st, 2015 at 8:09 pm
WD-40. Spray around the edges stuff gets between anything.
May 31st, 2015 at 9:11 pm
Have Mrs. take non-tac to carwash again.
May 31st, 2015 at 10:23 pm
Flip the car upside down!
May 31st, 2015 at 11:38 pm
Fire up the flux capacitor and have the decal repel the car.
June 1st, 2015 at 4:24 am
I’d try slipping some shim stock or a cut up pop can under it. Dull the edges with a little emery cloth to avoid scratches.
June 1st, 2015 at 10:18 am
I would say it’s time to delegate authority for removal and proper installation to better half.
On the other hand, dental floss and WD40 (or silicone spray) could be a quick fix.
June 1st, 2015 at 10:23 am
If you can find a proper ground, plasma cutter should work.
Or floss.
June 1st, 2015 at 1:25 pm
You could just buy another one and laminate it on top of the old one with some Gorilla Glue. But be sure and check the headspace after.
June 1st, 2015 at 2:38 pm
Hmm, you could just tell people that it represents an AR rotated to use the offset BUIS, yes?
June 1st, 2015 at 5:27 pm
What Will said.
It’s an icon, not an actual bolt *in* a gun, with the handle facing up.
It’s fine.
June 5th, 2015 at 11:06 am
Not being an AR owner, never having fired one, never having taken one apart nor reassembled one, correctly or like a Bubba, I read way too many comments before getting the joke.
And any magnetic decal will come off at speeds around 200mph.