Interesting new suppressor design
Delta P Design Brevis II Ultra Silencer: It’s one piece and is short and fat. I’m curious about the internals of this thing.
I do wonder how you could clean it.
4 Responses to “Interesting new suppressor design”
Remember, I do this to entertain me, not you.
Uncle Pays the Bills
 |
|
Find Local
|
Categories
- ATF (769)
- Death Match (10)
- Eminent Domain (225)
- In the bag (9)
- Notes to Junior (546)
- Poker (74)
- Recipes (142)
- Shotgun Noob (11)
- The Airing of Grievances (19)
- uncategorized (47,725)
January 11th, 2017 at 8:03 pm
They have a giveaway drawing on their site for one.
https://deltapdesign.com/giveaway
January 11th, 2017 at 10:25 pm
Clean in an ultrasonic mineral oil bath with a circulating pump?
January 12th, 2017 at 10:36 am
Not super quiet. Expensive. I’ll wait for them to knock the manufacturing costs down a bit, as there is nothing magical about 3D printing except that it costs a lot, and for the retail price to become lower than the cost of any rifle I own.
I’d suggest MIM manufacturing to achieve whatever unusual baffle configuration they have inside the thing, at much lower cost and faster production rate.
But that is sooo 1990s!
January 15th, 2017 at 8:33 pm
There are designs that are impossible to implement via traditional manufacturing.
That makes 3d printing magical.
And the reason it’s expensive is because they’re using robots with freakin lasers to fuse metal powder and make “impossible” parts.